Instruction for work
6
Maintenance
1. After mowing, clean the cutter bar. When using
high-pressure jet cleaners NOT direct in
bearings!
2. Maintenance, repairs, cleaning and disturbance
removing may only be executed when the drive
and the engine are switched off and the ignition
key is pulled out!
3. Check nuts and screws regularly to be sure that
they are tightened enough. If not tighten them!
4. If you perform any maintenance on the lifted
implement, always secure the implement by a
suitable holder.
5. Use adequate tools and gloves when replacing
machine parts with sharp edges!
6. Store properly oils and greases!
7. Before repairs on electrical equipment are
started, switch off the electrical current – remove
the fuse!
8. If safety devices succumb to usage, must be
checked regularly and replaced in duet ime!
9. When welding on the tractor or on machine which
is mounted on the tractor, disconnect the cable
from battery and from generator!
10. Use only genuine spare parts, they guarantee long
lifetime of the machine!
11. When filling in the gas, use for filling in exclusively
azote. Danger of EXPLOSION!
To Next Page
Loading...
