SIPOS AKTORIK 2SA5.6 - Page 51

Y070.020/GB Page 51
Operation instructions
SIPOS 5 PROFITRON, HiMod
6
Parameters and possible parameter values
6 Parameters and possible parameter values
Parameter
Default value
Explanation
Parameter value Other param.
Parameters for the communication with fi eldbus
PROFIBUS address
channel 1: 126
Only for available Profi bus interface.
For the details, refer to the Profi bus operation instructions (refer to chapter 1.5 „Supplementary
instructions“).
channel 1: 0
to
channel 1: 126
Fieldbus address of the actuator on channel 1.
PROFIBUS address
channel 2: 126
Only for available redundant Profi bus interface.
For the details, refer to the Profi bus operation instructions (refer to chapter 1.5 „Supplementary
instructions“).
channel 2: 0
to
channel 2: 126
Fieldbus address of the actuator on channel 2.
PZD 3
Parameter no. .. In the „PPO2“ process representation, four process data values (PZD) can
be fed with data from the actuator. The parameter numbers entered under
PZD 3 to 6 are valid for both channels 1 and 2.
PZD 4
Parameter no. ..
PZD 5
Parameter no. ..
PZD 6
Parameter no. ..
MODBUS address
channel 1: 247
Only for available Modbus interface.
For the details, refer to the Modbus operation instructions (refer to chapter 1.5 „Supplementary
instructions“).
channel 1: 1
to
channel 1: 247
Fieldbus address of the actuator on channel 1.
The following communication parameters, i.e. baud rate, parity and connection control time must match those of the
DCS (master).
MODBUS baudrate1
19200 Baud
Communication parameters on channel 1:
300, 600, 1200, 2400,
4800, 9600, 19200,
38400
Baud rate in bits per second.
Par/Stop MODBUS1
gerade 1 Stopbit
none 2 stopbits No parity and 2 stop bits.
even 1 stopbit Even parity and 1 stop bit.
odd 1 stopbit Odd parity and 1 stop bit.
MODBUS moni.time
channel 1: 3 s
0,1 to 25,5 s
Connection control time.
MODBUS address
channel 2: 247
Only for available redundant Modbus interface.
channel 2: 1
to channel 2:247
Fieldbus address of the actuator on channel 2.
Settings same as for Modbus channel 1 address.
The following communication parameters, i.e. baud rate, parity and connection control time must match those of the
DCS (master).
Baudrate MODBUS2
19200 Baud
Communication parameters on channel 2:
300, 600, 1200,
2400, 4800,
9600, 19200,
38400
Baud rate in bits per second.
MODBUS par/stop2
even 1 stopbit
none 2 stopbits No parity and 2 stop bits.
even 1 stopbit Even parity and 1 stop bit.
odd 1 stopbit Odd parity and 1 stop bit.
MODBUS moni.time
channel 2: 3 s
0,1 to 25,5 s Connection control time.