Y070.020/GB Page 53
Operation instructions
SIPOS 5 PROFITRON, HiMod
6
Parameters and possible parameter values
6 Parameters and possible parameter values
Parameter
Default value
Explanation
Parameter value Other param.
enable PosCntr
„ Position controller“
customer variant
0
Customer-specifi c software programming deviating from standard fi rmware..
Unauthorized setting of customer variants can lead to damage of the
actuator/valve/plant!
The customer-specifi c software programming is described in the supplementary operation
instructions and is part of the delivery.
Digit indication A digit other than 0 indicates a customer-specifi c software version.
enable sp. setp.
„ External analog output speed setpoint“.
enable n curve
„ Travel-dependent output speed adjustment“.
en. prop / split
„Proportional/split range function“.
en.PosTimeCurve
„ Travel-dependent freely settable positioning times“.
Sep. mounting
Parameter for separate mounting.
Parameter is important for fault-free operation of the actuator!
For incorrect setting, a block might not be detected and the actuator switches off for lower torque
None or <= 10 m Setting if no separate mounting or separate mounting of less than 10 m is
used.
>10m with fi lter Setting for separate mounting of more than 10 m with LC fi lter.
return to menu
Press ENTER to return to the „commissioning“ menu.
To Next Page
Loading...