Sistemes Electrònics Progrés s.a. AGRONIC 2500 User Manual

18
6. PARAMETERS
To install and set the equipment up for operation, it is necessary to enter the “PARAMETERS” section and
adapt them to the needs of each facility. Access the menu by pressing “Fun. \ 4 \ Enter”.
The menu is divided into eight sections. To enter one of them, just press the corresponding index number or
move to the selection with the arrow keys and then press “Enter”.
If a menu has more than 5 lines, the “↓“ symbol will be displayed to indicate that they do not fit on the screen,
so press the index number or move the “Down Arrow” key to access them.
6.1. FERTILIZATION PARAMETERS
The Agrónic 2500 can operate with a maximum of four fertilizers that are applied in series (one after another)
or in parallel (all at once), in units of time or volume and separate pre/post irrigation for each program.
In the “N. of fertilizers” question, we indicate to the equipment the
number of fertilizers installed in the irrigation system, with a maximum of 4.
Leave the value at 0 if there are none.
The fertilizer general is an output normally used to connect the injec-
tor in application by series, and is activated only when one of the fertilizers
activates.
Each fertilizer can be assigned a separate mixer.
Before a fertilizer is applied, it is possible to mix up the liquid in the
tank. To do this, enter the number of seconds necessary in the pre-mixing
question. Once the injection value of a fertilizer has been entered, perma-
nent, intermittent or stop mixing can be carried out. For the first condition,
only enter the “start mixing” time, for the second both the starting and
stopping times, and for the last, just the stop time. The time limit is 255
seconds.
When the fertilization ends, a cleaning of the fertilization head can be done. If the fertilization is in series, it
will be done when each of the fertilizers is finished. If it is not in series, it will be done when all the fertilizers are
finished. The general of fertilizer is activated together with the cleaning output. The maximum time is 999".
PARAMETERS
1.
Fertilization
2.
Filters
3.
Generals
4.
Programs
5.
Sectors
↓
6.
Communications
7.
Various
8.
Installer
FUNCTION
1.
PROGRAMS
2.
MANUAL
3.
READINGS
4.
PARAMETERS
FERTILIZATION PARAMETERS
N. of fertilizers: 4
Fertilizer general: yes
Mixer F1: no
Mixer F2: yes
Mixer F3: yes
Mixer F4: no
Pre-mixing: 015 “
Mixing start: 030 “
Mixing stop: 120 ”
Last cleaning: 030 “

Sistemes Electrònics Progrés s.a. AGRONIC 2500 Specifications

General

Brand	Sistemes Electrònics Progrés s.a.
Model	AGRONIC 2500
Category	Controller
Language	English