sitrex MX 8 - Page 28

ASSEMBLY STEPS
26
24. CAUTION
Attach rake wheels lifting pipes 1-2 to sections 11 & 12 (LH - RH), beginning at point A. At the
same time, the chain
attachments 6 should
be placed in the
positions shown, as
well as the
connectors 4. Pipes
1 must also pass
through the correct
openings of
attachments 5(see
figure 24.b). At this
point connect
attachments 5 to
spots C on pipes 1,
using screws 8 and
nuts 9 (see figure
24.b). Connect pipes
1 & 2 using
connectors 4, screws
8 and nuts 9. Fasten
in the positions
shown the chain
attachments 6 using
screw 7 (see figure
24.a).
In this step, you will
use:
Item 7:
8/10 - screws M 10 x
25
(D 25/64" x 1")
Item 8:
12 - screws M 8 x 60
(5/16" x 2" 23/64)
Item 9:
12 - nuts M 8
(5/16")
24