GENERAL INSTRUCTIONS FOR FIELD USE
42
7. General instructions for field use
43. CAUTION
The first thing to be done in the field is to remove transport arms 1 & 2, replacing pins 3 in holes
A & B and fastening them with
clips 4. The transport arm
assemblies are to be placed
over pins C & D on the rake
wheel sections as shown.
Paste the transport arms to
pins C & D with clips 5.
In this step, you will use:
Item 5:
4 - clips D 3
(D 1/8").
IMPORTANT
Before starting raking operation make sure that the transport lock arms have been removed from
the transport position and set in working position.
Transport lock arms cannot be used to lock one raking wing, R.H. or L.H in order to work on one
side only because this is not allowed.
By operating the opening cylinders the machine is opened to the fully open position. If work
must be done on particularly uneven ground, do not operate in the fully open position. Open the
machine so that the working width is at most 3' narrower than the fully opened position.
43
UNFOLDING
To Next Page
Loading...
