CONNECTION TO THE TRACTOR AND TRANSPORT
41
41. CAUTION
At this point it is necessary to attach the transport arms. Insert arm 1 in arm 2 and lock in place
with pin 3 and clip 4. The
transport arm assembly is
then attached by placing
the fork of arm 1 on
attachment A of the
drawbar and the fork of
arm 2 on the rake wheel
section.
Fasten with pins 3 and
clips 4.
In this step, you will use:
Item 3:
6 - pins D 15 x 95
(D 19/32" x 3" 47/64")
Item 4:
6 - clips D 3 (D 1/8")
42.
This is the assembly diagram for the MX 8 and MX 10. The row of holes on the arms is for when
the rear axle is widened. Under no circumstances should the cylinders be operated while the
transport arms are attached. The machine is now ready to be transported to the work site.
41
42
To Next Page
Loading...
