WARNING
Make sure par king brake is fully
disengaged before operating the
snowmobile. When you ride the
vehicle, brake pads that are caused
to drag by a continuous pressure
on the lever may cause damage to
the brake system and cause loss o f
braking capacity and/or fire.
To Enga ge Mechanism
Squeeze brake lever and maintain
while pulling loc king lever wi th a fin-
ger. When brak e lever is held at
halfway the parking brak e should be
fully applied.
CA UTION: Parking brake position
can vary depending o n brake pads
wear. Ensure when the parking
brake is applied that the vehicle
stays securel y in plac e.
NOTE: Locking lever ca n be adj us t ed
in two different positions.
mmo2007-009-037_a
TYPICAL — ENGAGE M ECHANISM
Step 1: Squeeze and m aintain brake lever
Step 2: A djust locking lever
1. Position 1
2. Position 2
3. OFF
To Release Mechanism
Squeeze brake lever. Locking lever
will automatically return to its origi-
nal position . Alw ays release parking
brake before ridi ng.
mmo2007-009-037_b
TYPICAL — RELEASE MECHANISM
Step 1: Squeeze brake lever
9) Electronic Rev erse
(RER) Button
When pres s ed, it allows selection
the electronic reverse, refer to SHIFT-
INGINREVERSEin OPERATING IN-
STRUCTIONS se ction for proc edure.
mmo2007-003-003_e
1. Electronic Reverse (RER) Button
10) Headlamp Dimmer
Button
When pres se d, it allows se lect ion of
headlamp H I or LOW beam.
A gauge pilot lam p will indi cate head-
lamp HI beam pos iti on.
Lights ar e a utom atically ON whenev er
the engine is running.
_________ ____________
45
To Next Page