ELECTRICAL SYSTEM
Recommended Spark Plug
CA UTION: Use onl y spark plug NGK
PZFR6F. This spark plug is special-
ly design for the 600 HO E-TEC en-
gine. It must be installed to a spe-
cific torque, refer to SPARK P LUG
INSTALLATION for proper installa -
tion procedure. Do not attempt to
adjust gap on this plug.
Spark Plug Removal/
Installation
Removal
Ope n LH side panel.
Remov e belt g ua rd, refer to BELT
GUARD REMO VAL.
Unplug spark p lug cables.
mmo2008-008-027_a
LH SIDE OF ENGINE COMPART MENT
1. Spark plugs
Using tools from tool kit, unsc rew
spark plugs one turn.
mmo2008-008-009
1. 16 mm socket
2. Screwdriv er rod
Clean s pa rk plugs and cylin der heads
with pressurized air if possible.
WARNING
Always wear safety gogg les when
using pressurized air.
Unscrew spark plugs complete ly th en
remove them.
Installation
Prior to install ation, make sure that
contact surfaces of cylinder head and
spark plugs are free of grime.
Using a feeler ga uge, ve rify s pa rk plug
gap.
Replace spark plug if not within spec -
ifications.
CA UTION: Do not attempt to adjust
gap on these plugs.
Spark plug gap
Not adjustable.
0.8+0mm/-0.1mm
(.031 + 0 in/- .004 in)
Screw spark plugs into cylinder head
by hand until it bottoms.
Tighten plugs using tools from tool kit
or w ith a t orque wrench and a proper
socket.
Using Tools from Tool Kit
Use the 16 mm socket and the scre w-
driver rod from the vehicle tool kit.
mmo2008-008-008_a
TOP V IEW
1. 16 mm socket
2. Screwdriv er rod
Torque s pa rk plugs as per the f ollo w-
ing illustrations.
NOTE: Ensure spark and washer sits
properly on cylinder head.
94
_________ _____________
To Next Page