mmo2008-003-043
INSERT TOOL
Loosen lo cking nut by turnin g th e tool
counterclockwise (± 4 turns).
mmo2008-003-044_a
TURN TOOL COUNTERC LOCKWISE
Then , to open the dri v en pull ey use the
following tool from tool kit.
mmo2008-003-042
SUSP ENSION ADJUSTM ENT TOOL
Completel y open the driven pul ley by
turning the suspension adjustment
tool cloc k wi se .
Turn tool clockwise until it b ottoms .
mmr2008-042-001_a
1. Suspension adjustment tool
2. Adjustment ring
To remove the drive belt, slip the belt
over the top of driven pulley.
mmr2008-042-002
Remove drive belt from drive pulley.
Install and adjust drive b elt, re-
fer to DRIVE BELT INSTALLATION/
ADJUSTM ENT.
D rive B el t I nstal lati on/
Adjustment
NOTE: The drive belt height must be
checked each time a drive belt is in-
stalled and should be recheck ed a fter
50 km (30 m i).
The max imum drive belt life s pa n is
obtained when the arrow on the drive
belt is directed toward the front of the
vehicle . This wil l ensure that correc t
direction of ro tation is r es pec ted.
84
_________ _____________
To Next Page