DRIVE SYSTEM
Belt Guard Removal and
Installation
WARNING
NEVER operate engine:
– without shields and belt guard
securely installed
– with hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
mentstomovingpartswhileen-
gine is running.
NOTE: Belt gua rd is purposely m a de
slightly oversize to m a intai n tension on
its pins and retainers preventin g un-
due n oise and v ibration. It is importa nt
that this tens ion be maintained wh en
reinstalling.
Remove the tether cord cap (DESS
key).
Ope n engine co mpartm ent LH side
panel.
Remove retaining pin.
mmo2008-007-016_a
1. Retaining pin
Lift rea r po rtion of guard then release
from upper retain ing pin a nd front
tabs.
When reinstalling belt guard, position
its cutaway tow a rd front of s nowmo-
bile.
Place b elt guard slots over tabs.
mmo2008-007-014_a
1. Slot
2. Tab
Position top portion of belt gua rd ov er
retaining pin.
mmo2008-007-015_a
1. Retaining pin
Position rear p ortion of belt guard over
retainer and secure using reta inin g pin.
mmo2008-007-016_a
1. Retaining pin
82
_________ _____________
To Next Page