BODY/FRAME
Vehicle Cleaning and Protection
Remove any dirt or rust.
To clean the entire vehicle, use only flannel cloths or equivalent.
CAUTION: It is necessary to use flannel cloths or equivalent
on windshield and hood to avoid damaging further surfaces to
clean.
To clean the entire vehicle, including bottom pan and metallic parts
use Heavy duty cleaner (P/N 293 110 001) (spray can 400 g) and
(P/N 293 110 002) (4 L)).
CAUTION: Do not use Heavy duty cleaner on decals or vinyl.
For vinyl and plastic parts use Vinyl & Plastic Cleaner ((P/N 413 711
200) (6 x 1 L)).
To remove scratches on windshield or hood use BOMBARDIER*
Scratch Remover Kit (P/N 861 774 800).
CAUTION: Never clean plastic parts or hood with strong deter-
gent, degreasing agent, paint thinner, acetone, products contain-
ing chlorine, etc.
Clean sheaves of both pulleys using Pulley flange cleaner (P/N 413
711 809).
Inspect the hood and repair any damage.
Touch up all metal spots where paint has been scratched off. Spray
all metal parts including shock chromed rods with BOMBARDIER
LUBE (P/N 293 600 016).
Wax the hood and the painted portion of the frame for better protec-
tion.
NOTE: Apply wax on glossy finish only. Protect the vehicle with a
cover to prevent dust accumulation during storage.
CAUTION: The snowmobile has to be stored in a cool and dry
place and covered with an opaque tarpaulin. This will prevent
sun rays and grime from affecting plastic components and vehi-
cle finish.
Lift rear of vehicle until track is clear of the ground. Install on a wide-
base snowmobile mechanical stand with a rear deflector panel.
_________________________
203
To Next Page
Loading...
Need help?
General
