Ski-Doo REV Series User Manual

1
A32D15A
TYPICAL
1. Arrow pointing front of vehicle
CAUTION: Do not force or use tools to pry the belt into place, as
this could cut or break the cords in the belt.
To install the drive belt, first place belt between drive pulley sheaves.
Then, between driven pulley sheaves, finishing with bottom.
Remove drive belt installer/remover. Reinstall belt guard.
Close engine compartment.
DrivePulleyAdjustment

WARNING
Remove tether cord cap before performing any maintenance
or adjustment, unless otherwise specified. Vehicle must be
parked in a safe place, away from the trail.
General
The drive pulley is factory calibrated to transmit maximum engine
power at a predefined RPM. Refer to SPECIFICATIONS section in
this guide. Factors such as ambient temperature, altitude or surface
condition may vary this critical engine RPM thus affecting snowmo-
bile efficiency.
_________________________
189

Ski-Doo REV Series Specifications

General

Chassis	REV
Track Width	15 in
Fuel Capacity	10.6 gal
Seating Capacity	1
Reverse	Available on most models
Electric Start	Available on most models