EasyManuals Logo

Ski-Doo REV Series User Manual

Ski-Doo REV Series
227 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
WARNING
Do not attempt to lift the vehicle by hand alone. Use appro-
priate lifting device or have assistance to share lifting stress in
order to avoid risk of strain injuries.
NOTE: Do not release track tension.
Bulb Replacement
Always check light operation after bulb replacement.
Headlamp
CAUTION:
Never touch glass portion of an halogen bulb with
bare fingers, it shortens its operating life. If glass is touched,
clean it with isopropyl alcohol which will not leave a film on the
bulb.
Unplug burnt bulb connector. Remove the rubber boot.
2
A33E0CA
1
1. Bulb connector
2. Rubber boot
Turn bulb locking ring counterclockwise to remove it. Detach the
bulb and replace. Properly reinstall parts.
204
_________________________

Table of Contents

Other manuals for Ski-Doo REV Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ski-Doo REV Series and is the answer not in the manual?

Ski-Doo REV Series Specifications

General IconGeneral
ChassisREV
Track Width15 in
Fuel Capacity10.6 gal
Seating Capacity1
ReverseAvailable on most models
Electric StartAvailable on most models

Related product manuals