To Next PageTo Next PageWhat to do if my skilsaw SPT67FMD Saw won't start?
If your skilsaw Saw does not start, try the following: * Ensure the saw is properly plugged in. * Replace the fuse or reset the tripped circuit breaker. * Inspect the cord for any signs of damage. If the cord is damaged, it should be replaced by an authorized service center.
What to do if cut binds, burns, stalls motor when ripping with skilsaw SPT67FMD Saw?
If the cut binds, burns, or stalls the motor when ripping with your skilsaw Saw, try the following: * Discard the blade and use a different blade. * Make sure the concave or hollow side is facing 'DOWN' and feed slowly. * Assemble the blade and tighten the Vari-Torque clutch.
What to do if blade slipping on skilsaw Saw?
If the blade is slipping on your skilsaw Saw, assemble the blade and tighten the Vari-Torque clutch.
General| Type | Circular Saw |
|---|---|
| Motor | 15 Amp |
| Blade Diameter | 7-1/4 inches |
| Corded/Cordless | Corded |
| Electric Brake | Yes |
| Dust Port | Yes |
| Max Cut Depth at 90° | 2-7/16 inches |
| No Load RPM | 5, 300 RPM |
Explains the meaning of safety symbols like DANGER, WARNING, CAUTION.
Covers keeping work area clean, well-lit, electrical safety, and wet conditions.
Emphasizes staying alert, using common sense, and wearing protective equipment.
Covers preventing unintentional starting, proper reach, dressing, and tool care.
Directs users to keep hands away from the blade, use guides, and secure workpieces.
Guides on setting cutting depth, guard function, and proper blade exposure.
Instructions on checking, using, and maintaining the lower guard.
Covers kickback definition, grip, support, blade care, adjustment levers, and clutch function.
Specifies intended material, blade type, and vacuum system use for safety.
Step-by-step instructions for attaching the saw blade securely.
Instructions for adjusting the cutting depth and checking the depth scale.
Steps for adjusting the bevel angle up to 45° and beyond.
Lists potential causes and remedies for the saw failing to start.
