Selector key NAV (Navigation) 41
Determining the parameters for the route calculation
The menu Route options is called up ⇒ page 40, fig. 16 by pressing in the
main menu Navigation ⇒ page 40, fig. 15. The menu Route options is used to
determine the criteria according to which a route is to be calculated and what types
of destination you wish to allow for the route calculation.
The changes in the menu Route options must be confirmed with , as they
cannot be taken over otherwise.
– opens a pop-up window:
• Fast: It calculates the fastest route to your destination, even if a detour is neces-
sary.
• Short: Longer driving time in favour of a shorter route is acceptable. Please
note that the setting “Short route” during route guidance can sometimes lead to
unexpected results.
• Economical: The aim of the calculation is a balance between minimal driving
time and driving distance.
– opens a pop-up window where it is determined whether and
how TMC traffic reports are to be included in the route calculation (Manual or
Automatic).
, , or – Determines whether these
types of destinations should or should not be used. These types of destinations will,
however, be used for the route calculation if there is no other logical route to the
destination (e.g an island is to be used without using a ferry).
Options
OK
Route
Dynamic route
Freeways Ferries Toll roads Tunnels
s2u4.6.book Page 41 Wednesday, August 13, 2008 7:57 AM
To Next Page
Loading...
Need help?
General
