– The plug -5- is placed onto the multi-function switch.
– Push selector lever control cable -1- onto the gearshift lever
-6-, while ensuring that the selector lever control cable does
not get kinked.
Note
Under some circumstances the gearshift lever must be shifted in
the correct position, in order to be able to push on the selector
lever control cable.
– Inspect setting of selector lever control cable
⇒ “2.3 Inspecting and adjusting the selector lever control ca‐
ble”, page 55 .
Tightening torques
Component Nm
Multi-function switch - F125- to gearshift shaft 7
Gearbox shift lever to gearshift shaft 13
2.2 Setting multi-function switch - F125-
Special tools and workshop equipment required
♦ Setting gauge - T10173-
– Shift selector lever to position “N”.
– Switch off ignition.
– Remove air filter ⇒ Engine; Rep. gr. 24 .
– Lever off the selector lever control cable -1- from the gearshift
lever -3-, e.g using an open-end wrench -2-, while ensuring
that the selector lever control cable does not get kinked.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
2. Removing, installing and setting multi-function switch F125 187
ProCarManuals.com
To Next Page
Loading...
