Skoda Superb II 2008 - Removing and Installing the Cover for the Shift Mechanism

2.5 Removing and Installing the cover for
the shift mechanism
⇒ “2.5.1 Removing and Installing the cover for the shift mecha‐
nism - Fabia II and Roomster”, page 58
⇒ “2.5.2 Removing and Installing the cover for the shift mecha‐
nism Superb II”, page 59
⇒ “2.5.3 Removing and Installing the cover for the shift mecha‐
nism Octavia II”, page 60
⇒ “2.5.4 Removing and Installing the cover for the shift mecha‐
nism Rapid”, page 62
⇒ “2.5.5 Removing and Installing the cover for the shift mecha‐
nism Octavia III”, page 62
⇒ “2.5.6 Removing and Installing the cover for the shift mecha‐
nism Yeti”, page 63
2.5.1 Removing and Installing the cover for
the shift mechanism - Fabia II and
Roomster
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
Removing
Note
As of 11.2012, the selector lever handle was changed
⇒ “2.1.5 Summary of components - Shift mechanism as of
11.2011 (Fabia II and Roomster)”, page 49 .
– Push selector lever into position “N”.
– Switch off ignition.
Note
Make sure that the vehicle does not put itself into motion.
– Carefully press the disassembly wedge - 3409- in
-direction of arrow- and subsequently clip the cover -1- out of
the centre console.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
58 Rep. gr.37 - Controls, housing
ProCarManuals.com