Skoda Superb II 2008 - Checking the Torque Converter; Installing the Torque Converter

– Drive in new gasket ring for torque converter with thrust piece
- T10175- up to the stop.
1.3 Checking the torque converter
– Check hub -arrow- of torque converter for traces of wear.
Note
The torque converter is welded and must be replaced completely
if damaged or faults.
1.4 Installing the torque converter
Special tools and workshop equipment required
♦ Depth gauge
Work procedure
– Carefully push the torque converter hub through the gasket
ring up to the first stop on the input shaft.
– Press the torque converter by hand into the converter housing
and turn it until the recesses catch into the torque converter
hub in the driver of the inner gear of the ATF pump and the
torque converter locks audibly into place.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
18 Rep. gr.32 - Torque converter
ProCarManuals.com