4
●
to avoid creating static that may damage the equipment. In areas where static electricity is common,
or during dry times of the year throughout the country, touch the kiln lid handle before touching the
controller to discharge the static.
● As with all electrical products there is danger of electrical shock. Use only properly sized and rated copper
wire when installing the power supply for your kiln. We recommend this work is done by a licensed
electrician.
● Kilns should always be located in a dry place to prevent electrical shock and corrosion.
●
installing any Skutt Product.
●
be set off when the kiln is at peak temperature. This should be tested with the kiln at peak temperature,
●
● Skutt Ceramic Products Inc. will not assume liability for injury or damages caused by variations from the
instructions put forth in this manual.
●
sensitive objects and living things.
● Ventilation is key to maintaining a healthy work environment and proper room temperature. Proper
installation of a Skutt Envirovent 2 will clear potentially harmful fumes from the room. To ensure proper
● The proper placement of thermocouples is crucial to the proper operation of all automatically controlled
kilns. Check all thermocouples for damage and correct placement. Thermocouples must protrude into
the kiln chamber at least 1” to ensure an accurate reading.
● Only use the stand that is designated by Skutt Ceramic Products for your particular kiln model. Other
stands may not properly support the weight of your kiln, provide adequate clearance, and could pose a
●
cord.
● Make sure the power cord is routed in such a way as to not touch any portion of the kiln that gets hot.
● Be careful of pinch hazards when working on or assembling the kiln.
● Be sure to properly tension the springs on kilns equipped with lid lifters.
● Always unplug the kiln before performing any repairs or general maintenance. If your kiln is wired direct,
turn off the breaker.
● Use only Skutt replacement parts. Improperly sourced parts may pose a hazard to you and your kiln and
void your warranty.
●
and your kiln and void your warranty. Items such as alternative thermocouples, controllers, kiln coatings
may ruin your kiln if improperly installed or applied.
● Replace any electrical components that are discolored ,brittle, or corroded.
● Inspect all stainless steel bands to ensure they are tight. If they are loose, tighten them as much as
Safety
To Next Page
Loading...
