45
Appendix 5 — Electrical Requirements
Most important to proper operation of your new kiln is to make sure it has enough of the correct
power to operate. If this is done, your kiln will give you years of satisfying service; if not, your
receptacle, have the electrician follow this guide:
Three-phase operation
a single phase kiln. This is possible in most cases,
however, you should have this connection made
by a licensed electrician who is familiar with
phase kiln to 1 phase supply.
Voltage
As you can see from the chart, most Skutt models
While 120/240V supply is still by far the most
common supply in residential communities,
in commercial areas, schools and occasionally
supply, do not connect it. Doing so could damage the kiln and possibly overheat wiring in your
electrical supply. Contact the factory for instructions on how to safely convert your particular model.
714 Wiring
IMPORTANT:
one takes the solid white neutral wire.
15-506-5014-306-306-205-205-15 14-60
To Next Page
Loading...
