Skutt KilnMaster - Quick Start; CONE FIRE MODE; THE RAMP;HOLD MODE

7
Quick Start
Quick Start
Quick Start is a memory aid, not a substitute to reading and understanding the manual.
Activate the power source by plugging in the kiln or controller. After plugging in the kiln, the display
will read WAIT
IdLE. On ZC
models you will also see “TC2” which indicates it is reading thermocouple 2. Begin all programming
in Idle Mode.
Be sure the controller is set to the right temperature scale before proceeding (Fahrenheit or Celsius).
CONE FIRE MODE
Step 1
● Press CONE FIRE
Step 2
● 
● Press ENTER
Step 3
● Input Cone number
● Press ENTER
Step 4
● Input a SPEED
● Press ENTER
Step 5
● Input hold time
● Press ENTER
Step 6
● Press REVIEW
Step 7
● Press START
THE RAMP/HOLD MODE
Step 1
● 
Step 2
● 
● Press ENTER
Step 3
● Input the number of segments
● Press ENTER
Step 4
● 
● Press ENTER
Step 5
● 
reach
● Press ENTER
Step 6
● 
● Press ENTER
Step 7
● Repeat steps 4 thru 6 until alarm

● Press ENTER
Step 8
● Press REVIEW
Step 9
● Press START