40
● Make sure element troughs in the brick are proper side up. Insert the new brick. This is easiest if a helper
holds the adjoining bricks away.
●
resistance.
●
thoroughly when sanding is completed.
●
Lid Maintenance
Skutt lids are coated with a refractory cement which helps protect the kiln chamber from falling brick
normal and should not get worse over time. If your lid does develop a larger crack, you can use a
thin coating of refractory cement to seal it. Large patch jobs are not recommended.
Remember to tighten the lid band and lid hardware on a regular basis. If the inside surface of the
Floor Repairs
without damage to the surface below. Remember to remove all glaze
drips before taking the kiln to porcelain/stoneware temperatures, where
tool, undercut the edges of the area to be patched. Use a spackling
Skutt. Sand smooth
Replacing Elements
electrical connector tools. We recommend you ask your Skutt dealer
about the procedure.
To Next Page
Loading...
