53
●
●
●
●
● NOTE To start the screws, lightly hit each screw with a hammer until the point has pierced the stainless steel
band.
●
● Slowly drill through the kiln wall brick into the kiln chamber
●
the kiln chamber. Tighten the thumbscrew.
● Uncoil the yellow thermocouple wire that is hanging from the bottom of the controller enclosure.
● Plug the thermocouple ends into the receptacle coming from the controller. There is only one way the plug
will engage the receptacle.
● The controller is now ready for use.
Thermocouple installation in a kiln not marked for a thermocouple.
●
so that you do not drill through an element. Do not drill yet.
●
position of the small holes on the jacket. Push hard or tap out with a nail and hammer the small screw
● For the remaining installation steps consult the previous section on Thermocouple Installation for a Skutt
Kiln.
Operating Instructions for Kilns with a Kiln - Sitter
correct operation with the controller.
● Place a Junior cone one or two numbers hotter than the cone equiva
●
ing.
● If your Dawson Kiln-Sitter is equipped with a limit timer, set the timer
power to your kiln on and off to control the temperature, the timer will
●
To Next Page
