Skydio X2E - Skydio Pre-Flight Procedures; Charging Skydio X2 E and Controller

To Next Page

To Previous Page

7 Skydio X2E / Quick Reference Guide

PRE-FLIGHT

Charge

Skydio X2E

Skydio Dual Charger is capable of simultaneously providing current to two batteries.

However, it will prioritize fully charging the battery with the highest charge level. Allow

approximately two hours to fully charge batteries.

The current charge level is accessed by pressing the power button on the battery. The

battery charge level is indicated by the lights:

X2E battery charge levels

Step 1 - Slide one or both batteries down the rails onto the Dual Charger

• magnets will engage properly seating the battery

Step 2 - Connect the provided USB-C cable and the 65 W power adapter

Step 3 - Plug the power adapter into the Dual Charger and

a 100-240 V power source

• ﬂashing lights indicate charging

• no light indicates that the charge is complete

WARNING: Avoid exposure to extreme hot or cold temperatures. Instructions and

warnings for battery storage are located in the X2E Operator Manual