C.Maintenance, servicing
D.Transportation and storage
E.Others
Storage for not using certain period
Put H16/H16 Pro in a dry and ventilated area. No direct sun light to prevent harm to the internal li-ion
battery. If store it over three months, it is highly recommended to put room temperature between 22℃ to 28 ℃.
DO NOT put it below 20 ℃ or higher than 45℃.
Warning
In order to prevent lost or getting hurt, please strictly follow the rules of operation:
Keep small parts or wire away from children can reach. DO NOT let children touch the small parts of H16/H16 Pro.
Attention
1） DO NOT put H16/H16 Pro into water. If it does, please switch off the power and dry it at once!
2） DO NOT crash the H16/H16 Pro or break the battery is prohibited.
16
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part
15 the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates uses an can radiate radio frequency energy and,if not installed
and used in accordance with the instructions,may cause harmful interference to radio communications.However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception,which can be determined by turning the equipment off and
on,the user is encouraged to try to correct the interference by one or more of the following.
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user`s
authority to operate the equipment.
To Next Page
Loading...
Need help?
General
