Skyjack SJ40 T+ - Grease Points; Grease the Turret Ring Gear; Grease the Turret Swing Drive

153
SJ40 T+, SJ45 T+ 238273AAA
Grease Points Section 5 – Procedures
5.9 Grease Points
Maintaining proper lubrication is essential for good performance and service life of the MEWP. If the
bearing and gear of the MEWPare improperly greased, it could result in component damage.
5.9-1 Grease the Turret Ring Gear
1. Open the control side cowling, and locate the turret ring gear grease fitting
1
between the hydraulic tank
and the main manifold.
2. Pump grease into the fitting, and continue pumping until new lube appears continuously around the grease
seal lip of the ring gear.
3. Rotate the turret in increments of 4 to 5 inches (10 to 13 cm) at a time, and repeat step 2 until the entire
bearing has been greased.
5.9-2 Grease the Turret Swing Drive
1. Apply open gear lube to each tooth of the swing drive gear
2
, located under the turret on the engine side.
1
2
To order go to Discount-Equipment.com