SkyLink SA-001S - Connecting to Your Existing Alarm System; Connecting to INPUT1 for Delayed Trigger; Connecting to INPUT2 for Instant Alarm

11
You may connect your existing alarm system with the Wireless External Alarm so
that the Wireless External Alarm will be triggered by your alarm system. There are
2 ways you can connect your Wireless External Alarm with your existing alarm
system. The input terminals (INPUT1 or INPUT2) can be a Normally Open (NO)
momentary dry contact or the DC voltage of 12V.
8A – Connect your existing alarm system to the INPUT1, this provides the
delay trigger until the Wireless External Alarm is armed.
8B – Connect your existing alarm system to the INPUT2, this provides the
instant alarm.
cONNEcT ThE WIrELEss ExTErNAL ALArm WITh
yOur ExIsTINg ALArm sysTEm
Learn/ Set