SkyLink SA-001S - Alert Notification Jumper Settings; Enabling or Disabling Audible Alerts

12
You can enable or disable the Alert Notication. When it is set to enable, the
Wireless External Alarm will beep when arm or disarm or during the entry/exit
countdown period. When it is set to disable, the Wireless External Alarm will not
beep when arm or disarm or during the entry/exit countdown period. However, the
LED will remain ashing as it is. The Wireless External Alarm will still siren when
it is triggered.
Unplug all the power (batteries and AC adapter) when setup the Alert Notication.
Factory default is set to “Enable”. To select, you will see a jumper connector marked
“J1” as shown below. Use a paper clip to remove the jumper connector and
re-locate to the proper posts. Apply the power to the Wireless External Alarm again
after setup the Alert Notication
A LErT NOTIFIcATION JumPEr
Alert Notication Jumper (J1)
Mode Jumper (J1) Setting
Enable
Set the connector to top 2
posts (1-2)
Disable
Set the connector to bottom 2
posts (2-3)