Skytech 3301P2 Installation And Operation Instructions

_________________________________________________________________________________________________
REV. 8/3/11 Page 2 of 7
Skytech 3301P2
MODE FUNCTION
To select an operational mode, press the MODE button.
ON turns the appliance ON. The flame icon will appear.
THERMO sets the remote to thermostatic mode.
OFF turns the appliance OFF. The flame icon will disappear.
SETTING ºF / ºC SCALE
The factory setting for temperature is ºF. To change this setting to ºC, press and hold the UP button and the DOWN button on the
transmitter at the same time. Follow this same procedure to change from ºC back to ºF.
SETTING THE CLOCK
Press and hold the SET button for 5 seconds. The hour section will begin to flash. (Fig. #1)
Use the UP and DOWN buttons to select the hour, then press SET.
The minutes will be flashing. Use the UP and DOWN buttons to select the minute, the press SET. (Fig. #2)
The AM PM will be flashing. Use the UP and DOWN buttons to select AM or PM, then press SET. (Fig. #3)
One of the days of the week will be flashing (above the clock). Select what day it is by pressing the UP and DOWN buttons, then press
SET. Your time will automatically be accepted. (Fig. #4)
THERMOSTAT FUNCTION
This remote control system can be thermostatically controlled when the transmitter is in the
THERMO mode (THERMO must be displayed on the screen). To set the desired room
temperature, press the MODE button to place the transmitter into thermo mode, then press the
UP or DOWN buttons to select the desired room temperature. The highest set temperature is 99
ºF (32 ºC).
NOTE: The thermo feature operates the appliance whenever the room temperature varies a certain number of degrees from the set
temperature. This variation is called the “swing” or temperature differential. This feature lets the appliance turn off and on 2 ºF (1 ºC)
above or below the set temperature of the room. This is to cushion the number of times the appliance is turned ON and OFF.
THERMO UPDATING FEATURE - TRANSMITTER
When in thermo mode, the transmitter reads the ROOM temperature every 2 minutes, checks the room temperature against the SET
temperature then sends a signal to the receiver.
Fig. #1 Fig. #2 Fig. #3 Fig. #4
UP
DOWN
MODE

Skytech 3301P2 Specifications

General

Brand	Skytech
Model	3301P2
Category	Remote Control
Language	English