SETTING
0
F /
0
C SCALE
The factory setting for temperature is
0
F. To change this setting to
0
C,
first
• Press the ON key and the OFF key on the transmitter at the same
time this will change from
0
F to
0
C. Follow this same procedure to
change from
0
C back to
0
F.
MANUAL FUNCTION
To operate the system manually perform the following:
ON OPERATION
Press the ON key the appliance flame will come on. The Flame icon will
appear on LCD screen in ON mode
OFF OPERATION
Press the OFF key the appliance flame will shut off. The Flame icon will
not appear on LCD screen in OFF mode
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the
transmitter is in the THERMO mode (The word THERMO must be
displayed on the screen). To set the THERMO MODE and DESIRED
room temperature, press the SET key and the word THERMO will
appear on the LCD screen;; the remote is in the thermostatic mode.
Press and hold the SET key until the desired set temperature is
reached. (By pressing and holding the set key the LCD screen set
numbers will increase from 45
0
to 99
0
then restart over at 45
0
) Next
release the SET key. The LCD screen will display the set temperature
for 3 seconds and the LCD screen will flash the set temperature for 3
seconds, then the LCD screen will default to display the room
temperature:
TO CHANGE THE SET TEMPERATURE
Press and hold the SET key until the desired set temperature is
reached. (By pressing and holding the set key the LCD screen set
numbers will increase from 45
0
to 99
0
then restart over at 45
0
) Next
release the SET key. The LCD screen will display the set temperature
for 3 seconds, then will flash the set temperature for 3 seconds, then the
LCD screen will default to display the room temperature.
To Next Page
Loading...
Need help?
General
