Page 1
17 - REMOTE CONTROL OPERATION INSTRUCTIONS
B. REMOTE CONTROL INFORMATION
Figure 17A
Remote:
Skytech Premium Transmitter Model AF-4000TSS02 comes standard with the replace.
Touch Screen LCD
Takes four (4) AAA batteries (included)
A. REMOTE ICON IDENTIFICATION
IMPORTANT ELECTRICAL WARNING AND INFORMATION
Electrical wiring must be installed by a licensed electrician.
• Do NOT wire 110V to wall switch.
• Uninterrupted or continuous power is required at all times in IPI systems EXCEPT when using battery back-up.
• Incorrect wiring will override IPI safety lockout and may cause an explosion.
• Disconnect 110V before servicing
A double receptacle box cover and (3) wire nuts are supplied in replace components packet to be used when hardwiring to electrical box
located under rebox on right side of replace.
IMPORTANT ELECTRICAL WARNING AND INFORMATION
THIS SYSTEM GOES THROUGH A CALIBRATION MODE WHEN SWITCHING FROM ‘ON’ TO ‘THERMO’ TO ‘OFF’ MODES, CREATING A
HUMMING SOUND WHICH IS A NORMAL PART OF OPERATION.
SET TEMP Zone
FLAME Zone
FAN Zone
DOWN Button
MODE/SET Button
MODE Zone
ROOM TEMP Zone
TIME/PROG Zone
LIGHT Zone
AUX Zone (not used)
UP Button
To Next Page
Need help?
General
