To Next Page

To Previous Page

Page 4

17 - REMOTE RECEIVER INFORMATION

L. MANUAL MODE

M. FAN MODE

N. LIGHTING MODE

Thisremotecanbemanuallyorthermostaticallyoperated.

Press MODE/SETbuttonformanualON.Theameiconwillappearon

the LCD screen. Press MODE/SETbuttonagaintoputthecontrolinto

THERMO mode. Pressing MODE/SETagainwillturnreplaceOFF.

Thisremotewilloperatethefan,allowingfor(6)differentspeedlevels.

Press the MODE/SETbutton.TheFANicon(*)willlightup.Pressthe

FAN icon on the LCD screen, then the UP or DOWN ARROWS to select

thedesiredfanspeedlevel.PresstheMODE/SETbuttontosetorwait

15secondsandthecontrolwillautomaticallyacceptthenewsetting,exit

function setting mode and LCD display will return to normal view.

Thisremotewilloperatethelights,allowingfor(6)differentlightlevels.

When LIGHTbuttonispressed,PresstheMODE/SETbutton.TheLIGHT

iconwillappearontheLCDscreen.PresstheLIGHT icon on the screen.

Press UP or DOWNbuttonstoselectdesiredlightlevel.PresstheMODE/

Setbuttonorwait15secondsandthecontrolwillautomaticallyacceptthe

newsetting,exitfunctionsettingmodeandLCD display will return to normal

view.

Figure 17L

Figure 17N

Figure 17M

IMPORTANT NOTE

Delayed ON/OFF - The fan will not turn on until replace has been

burning for 5 minutes and will not turn off for 12 minutes after

replace has been turned off.

EXCEPTION: If replace is turned back on during 12 minute off-

delay time frame, the fan will remain on. This applies to MANUAL and

THERMO modes

IMPORTANT NOTE

The MODE/SET button operates in a series that will cycle from ON to

THERMO to OFF.

NOTE

The replace does not have to be burning to operate the lights.

Skytech AF-4000TSS02 User Manual

Questions and Answers: