press and hold and “UP” buttons for 5 seconds, “ ” will
briefly appear/disappear on screen.
6) Swing Setting: Press the and “DOWN” buttons simultaneously
to enter Swing Setting mode.
z Operation Description:
1. Mode:
z ON OPERATION: Press the “MODE” key into the ON mode. The
appliance flame will come on. During this time the screen will show
ON and System ON flame. The TIMER function will be activated.
z THERMO OPERATION: Press the “MODE” key into the THERMO
mode. The transmitter will check the ROOM temperature and SET
temperature to decide the situation ON THERMO or THERMO OFF.
After 2 seconds the LCD screen will display the situation by
temperature detected that is comparing with the SWING temperature
scale.
z OFF OPERATION: Press the “MODE” key into the OFF mode. The
appliance flame will shut off. During this time the screen will show
OFF. The TIMER function will be shut down.
2. THERMOSTAT FUNCTION:
z SETTING DESIRED ROOM TEMPERATURE: This remote control
system can be thermostatically controlled when the transmitter is in the
THERMO mode. To set the THERMO MODE and DESIRED room
temperature, During the THERMO mode, Press “Up” / “DOWN” key
the LCD screen set numbers will increase / decrease between 45° and
99° Fahrenheit.
z THERMO ON situation: During this mode the screen will display the
set flame/valve at the same time enable the TIMER function setting.
z THERMO OFF situation: During the situation the TIMER function
will be shut down.
3. Setting Swing:
z To change the temperature “SWING” setting (1-3), press the
TIMER/TIME and DOWN buttons simultaneously to display the
To Next Page
Loading...
Need help?
Power
Frequency
