REV 11/27/07 Page 2 of 10
SETTING THE CLOCK
NOTE: When setting the clock the transmitter must be in the OFF position
1. Touch the word TIMER
on the LCD screen of the transmitter for more than two seconds.
The hour digit(s) will begin flashing.
2. Press the UP
or DOWN button until the desired hour is displayed in AM or PM.
3. After setting the desired hour, again touch and the word TIMER
on the LCD screen for more
than two seconds the minutes digits will begin flashing.
4. Press the UP
or DOWN button until the desired minutes are displayed.
5. Touch and release the word TIMER
on the LCD screen again for more than two seconds.
The minute digits will cease flashing, indicating the clock has been successfully set
NOTE: Flashing numbers on the display indicate the system is awaiting user input, such as using
the UP
and DOWN buttons to program a new setting. If no change is made to flashing digits
within 15 seconds, the system will complete the procedure last programmed and reset the display
to its normal state.
SETTING
0
F /
0
C SCALE
The factory setting for temperature is
0
F. To change this setting to
0
C, first press and hold the UP button and the DOWN button on the
transmitter at the same time. Follow this same procedure to change from
0
C back to
0
F. When changing between the
0
F and
0
C scales, the
temperature in the SET frame defaults to the lowest temperature (45
0
F, or 6
0
C). The highest SET temperature is 99
0
Fahrenheit (32
0
Celsius).
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the transmitter is in the THERMO
mode (THERMO must be displayed on the screen). To set the DESIRED room temperature, press the
MODE/SET button to place the transmitter into THERMO mode, then press the UP
or DOWN button to
select the desired room temperature. The highest SET temperature is 99
0
Fahrenheit (32
0
Celsius).
OPERATIONAL NOTE:
TO CONSERVE BATTERY POWER, CHANGES IN ROOM TEMPERATURE
ARE AUTOMATICALLY UPDATED EVERY TWO MINUTES TO THE TRANSMITTER.
SETTING THE TEMPERATURE SWING (TEMPERATURE DIFFERENTIAL)
The Thermo Mode on the transmitter operates the appliance whenever the ROOM TEMPERATURE varies
a certain number of degrees from the SET TEMPERATURE. This variation is called the “SWING” or
TEMPERATURE DIFFERENTIAL.
1. To change the temperature “SWING” setting (1º-3º), press the TIMER
and DOWN buttons
simultaneously to display the current “SWING” setting in the SET TEMP frame. The letter “S” will
display in the ROOM TEMP frame on the LCD screen.
2. Press the UP
or DOWN button to change the temperature differential or “SWING” (1º-3º).
3. To store the “swing number press the MODE/SET button or allow 15 seconds to lapse, and the
new “swing number’ will be automatically programmed.
MODE/SET
BUTTON SETTINGS
PM
ROOM
SET
TIMER
OFF
ON
THERMO
AM
PM
ROOM
SET
TIMER
OFF
ON
PM
ROOM
SET
TIMER
OFF
OFF
To Next Page
Loading...
Need help?
Power
Frequency
