REV. 5-20-22 Page 3
Skytech: 5301P
MODE FUNCTION
NOTE: Touch anyplace on the screen and the back light will light up and
stay lit for 5 seconds.
To select an operational mode, press the MODE button or touch the MODE
SECTION of the touch screen.
• ON turns the appliance manually ON; the ame icon will appear.
• THERMO sets the remote to Thermostatic mode.
• OFF turns the appliance OFF; the ame icon will disappear.
MODE
SET
PROG
Mode: Button
Mode: Touch
Portion
SETTING ºF / ºC SCALE
The factory setting for temperature is ºF. To change this setting to ºC, rst press and hold
the UP touch button and the DOWN touch button on the transmitter at the same time.
Follow this same procedure to change from ºC back to ºF.
NOTE: When changing between the ºF and ºC scales, the set temperature defaults to the
lowest temperature (45 ºF, or 6 ºC).
Fig. 4 Transmitter functions.
BASIC TRANSMITTER FUNCTIONS AND INITIAL SETUP
• Press and hold the SET button, or touch the SET section on the touch screen, for 5 seconds. The hour section should
begin to ash. (Fig. #5)
• Use the UP and DOWN touch buttons to select the hour, then press SET.
• The minutes will be ashing. Use the UP and DOWN touch buttons to select the minute, the press SET. (Fig. #6)
• The AM PM will be ashing. Use the UP and DOWN touch buttons to select one of them, then press SET. (Fig. #7)
• One of the days of the week will be ashing (above the clock). Select the correct day by pressing the UP and DOWN
touch buttons, then press SET. Your time will automatically be accepted. (Fig. #8)
SETTING THE CLOCK
Fig. 5 Hours.
Fig. 6 Minutes.
Fig. 7 AM/PM. Fig. 8 Days of week.
To Next Page
Loading...
Need help?
General
