Skytech 5310P User Manual

MODE FUNCTION
NOTE: Touch anyplace on the screen and the back light will light up and
stay lit for 5 seconds.
To select an operational mode, press the MODE button or touch the MODE
SECTION of the touch screen.
ON• turns the appliance manually ON; the ame icon will appear.
THERMO• sets the remote to Thermostatic mode.
OFF• turns the appliance OFF; the ame icon will disappear.
MODE
SET
PROG
Mode: Button
Mode: Touch
Portion
SETTING ºF / ºC SCALE
The factory setting for temperature is ºF. To change this setting to ºC, rst press and hold
the UP touch button and the DOWN touch button on the transmitter at the same time.
Follow this same procedure to change from ºC back to ºF.
NOTE: When changing between the ºF and ºC scales, the set temperature defaults to the
lowest temperature (45 ºF, or 6 ºC).
Fig. 4
BASIC TRANSMITTER FUNCTIONS AND INITIAL SETUP
Review COMMUNICATION SAFETY under TRANSMITTER section. This signal safety features provides an extra
margin of safety if the transmitter is out of the normal 20-foot operating range.
KEY AND TOUCHSCREEN SETTINGS
MODE1. - Switches the appliance On/Thermo/Off.
PROGRAM2. - Turns ON and OFF the program function.
SET3. - Used in different functions to conrm settings.
UP4. and DOWN - Used to change the time, set temp, and programming functions.
MODE
SET
PROG
1
1
2
2
3
4
3
Fig. 2
BATTERY ICON1. - Battery power is low. Replace Batteries in 2 - 4 weeks.
ROOM 2. - Indicates CURRENT room temperature.
SET3. - Indicates desired SET room temperature for THERMO operation.
FAHRENHEIT/CELSIUS - 4. Indicates degrees Fahrenheit or Celsius.
FLAME5. - Indicates burner/valve in operation.
MODE6. – Indicates operation mode of system.
UP and DOWN7. – These are used to adjust the Time, Set temperature, and Program
functions.
TIME and PROGRAM TIME8. – Indicates current time or program time setting when
editing program settings.
LOCK9. ICON - Disables the transmitter when lock is visible on the LCD screen.
PROGRAM ON/OFF10. – Indicates when Program 1 (P1) is ON or OFF, and indicates
when Program 2 (P2) is ON or OFF.
DAY of WEEK11. - Indicates current day of week, or program segment when editing
program settings.
LCD - LIQUID COLOR DISPLAY
1
2
3
4
5
6
7
8
9
10
11
Fig. 3
Skytech: 5310P
REV. 1-20-14 Page 2

Skytech 5310P Specifications

General

Brand	Skytech
Model	5310P
Category	Remote Control
Language	English