Skywalker X8 - Separating the Control surface from the Wing


PHOTO9B

10. SeparatingtheControlsurfacefromtheWing
Useaneworextremelysharpbladetocutthecontrolsurfacesidesfromthewing.YouwillNOTberemoving
thecontrolsurfacecompletely,justallowingittomoveupanddownwiththelongestsideuncut.Itis
recommendedtoleavea1.5millimetergapbetweenthewing
andthecontrolsurface.SeePhoto10A.


PHOTO10A
