Skywalker X8 - Wing Plate Bonding with Servo Extension Installation

11. WingPlateBondingwithServoExtensionInstallation
Ifyouareusingdragrudders,doNOTdothisstepuntilyouhavereadandcompletedAppendixA.Spreadglue
ontotherecessinthewingwherethewingplatewillsit.MakesureyoudoNOTcovertheWingTubeareawith
glue.Carefullyinserttheservoextension
intothewingpanelcut‐outchannel,makesurethattheservowireis
firmlyinplaceandtheextensionistightfromtheservo.Spreadglueevenlyontothewingplateallowingthe
wingglueandwingplatetodry(about5minutes).Carefullycompressthewingpaneltothe
wingadjustingfor
fit.Trytomakesurethatthebuttendofthewingplateisevenwiththeendofthewing.SeePhotos11A,11B,
11Cand11D.



PHOTO11A


PHOTO11B