Skywalker X8 - Glue the winglet butt-plate to the winglet

Assembly Instructions
1. Gluethewingletbutt‐platetothewinglet
Spreadthesuppliedglueevenlyoverthewingletbottom.Alsospreadthesuppliedglueononesideofthe
woodenbutt‐plate,(makesurethisisNOTthebutt‐platemarkedwitha“T”).Waitapproximately5minutesfor
thegluetodryuntilitisnolongersticky.Do
thisforbothpiecesbeforepressingthemtogether,thiswillallow
youtobetteralignthewingletandthebutt‐plate.SeePhotos:1A,1B,1C,and1D.


PHOTO1A


PHOTO1B