Skywell 5 - FCC Statement; FCC Radiation Exposure Statement

If you have a question or a problem, please contact
1-844-SKY-WELL(759-9355) or email service@skywell.com for assistance.
15
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment may be used for applications that can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
1. Increase the separation between the equipment and receiver.
2. Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
3. Consult the dealer or an experienced radio/TV technician for help
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of the FCC RF Rules. This equipment must not
be co-located or operated in conjunction with any other antenna or tran-smitter. This
equipment should be installed and operated with a minimum distance of 5 millimeters
between the radiator and your body. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may cause
harmful radio frequency interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.