EasyManua.ls Logo

Skywell 5 - Quick Setup and Installation; Key Safety Considerations

Skywell 5
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If you have a question or a problem, please contact
1-844-SKY-WELL(759-9355) or email service@skywell.com for assistance.
3
QUICK SETUP AND INSTALLATION
To reduce risk of injury and/or property damage, please read the
Skywell User Manual in its entirety before assembling, installing and operating the
Skywell. Failure to follow the instructions in the Skywell User Manual could cause
personal injury or property damage.
Excessive Weight Hazard. Use two or more people to unpack,move
and install the Skywell. Always use 2 people to move the Skywell.
Unpack the Skywell and recycle the box.
Find the perfect spot for your Skywell on a hard level surface. It should have 8 inches of space,
in each direction, away from walls or furniture to ensure proper airflow and operation.
Plug the Skywell into a standard 3-prong grounded outlet. Turn on the Skywell at the on/off
switch located on the rear of the Skywell where the power cord enters the unit. Let the Skywell
begin making water. The unit may require at least 24 hours to generate a full tank.
We recommend that you break-in the water filters to avoid any taste inconsistency in your first
few gallons of Skywell-generated water. See page 6 for instructions (Water Filter Break-in Prior to
Use).
The drip tray may be removed and installed without opening the front door. The drip tray cover
may be removed to clean the drip tray. When reinstalling the drip tray, insert it downward securing
it into its docked position below the dispense point.
The Skywell should be upright for at least 4 hours prior to plugging it
into the electrical wall outlet. Plugging in shortly after the Skywell has been on its
side can damage the compressor.
NOTE: AFTER WATER GENERATION, IT MAY TAKE 90 MINUTES FOR COLD WATER TO
REACH ITS COLDEST TEMPERATURE.
KEY SAFETY CONSIDERATIONS
Plug the Skywell plug into a standard 3-prong grounded AC 120V,
60Hz outlet ONLY. Consult with an electrician if necessary.
The Skywell dispenses water as hot as 203° Farenheit (95° Celsius).
Use caution when dispensing hot water and do not allow children to dispense hot
water without proper and direct adult supervision.

Related product manuals