If you have a question or a problem, please contact
1-844-SKY-WELL(759-9355) or email service@skywell.com for assistance.
4
SAFETY PRECAUTIONS
Ensure you read the Skywell User Manual in its entirety before
installing and operating the Skywell for the first time.
When operating the Skywell, always exercise basic safety precautions including, but
not limited to, the following:
1. Prior to use, the Skywell must be properly assembled and installed in accordance with the Skywell User
Manual.
2. The Skywell is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other
purposes. The Limited Warranty is void if used to dispense any other liquids.
3. For indoor use only. Keep the Skywell in a dry place away from direct sunlight. Do NOT use outdoors.
4. Install and use only on a hard, flat and level surface.
5. Do NOT place the Skywell in an enclosed space or cabinet.
6. Do NOT operate the Skywell in the presence of explosive or inflammable fumes.
7. Position the Skywell no closer than 8 inches from a wall to permit free airflow between the wall and the
Skywell. There must be at least 8 inches of clearance on all the sides of the Skywell.
8. Use only properly grounded outlets.
9. Always grasp the plug and pull straight out from the outlet. Never unplug by pulling on the cord.
10. Do NOT use the Skywell if the cord becomes frayed or otherwise damaged.
11. To protect against electric shock, do NOT immerse the cord plug, or any other part of the Skywell, in
water or other liquids.
12. Ensure the Skywell is unplugged prior to cleaning or changing filters.
13. Never allow children to dispense hot water without proper and direct adult supervision.
14. Service should be performed only by a Skywell Certified Technician. Please contact us at 1-844-SKY-
WELL (1-844-759-9355) for assistance.
Do not tamper with the ozonator. Ozone is released in very small
quantities that have been verified as safe. Attempting to adjust the ozonator may
release more ozone than prescribed.
Electrical Shock Hazard
1. Plug your Skywell into a grounded 3-prong outlet only.
2. Do not remove the ground prong from the Skywell power cord.
3. Failure to follow these instructions can cause fire or electrical shock resulting in injury or even death.
A 120 volt, 60 Hz, AC only, 15-amp, fused electrical supply is required. A time-delay fuse or circuit
breaker is recommended. Do not overload the circuit. If required, provide a separate circuit to serve
only the Skywell. The Skywell must be plugged into a mating, 3 prong, grounding-type outlet; grounded in
accordance with local codes and ordinances. In the event of a malfunction or breakdown,
grounding will reduce the risk of electrical shock by providing a path of least resistance for electric
current. If a mating outlet is not available, it is the personal responsibility and obligation of the user to
have the properly grounded outlet installed by a qualified electrician. Do not ground to a gas pipe.
Do not have a fuse in the neutral or ground circuit.
To Next Page
Loading...
