EasyManua.ls Logo

Slaughter 2205 - Page 20

Slaughter 2205
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SPECIFICATIONS
16
INSULATION RESISTANCE TEST
Failure Settings Low Limit:
0.1MΩ – 999.9MΩ
1000MΩ – 9999MΩ
10.0GΩ – 200.0GΩ
Dwell Time Setting 1.0 – 999.9 seconds, 0.1 second / step
“0” for continuous running
Delay Time Setting 0.1 – 999.9 seconds, 0.1 second / step
Discharge Automatic Discharge of Device Under Test
Indicator: Green < 30 V, Red > 30 V
GENERAL
Remote Interface Provided through 9 pin D type connector
1. Inputs: test , reset, safety interlock
2. Outputs: pass, fail and test in progress
Line Cord Detachable 6 ft. (1.8m) power cable terminated in a three prong
grounding plug.
Terminations High Voltage Output – Alden Socket
Shielded Return – BNC Connector
Mechanical Dimensions: (W x H x D): (120mm x 133mm x 300mm)
Environmental Operating Temperature:
Relative Humidity:
32° − 104°F (0° − 40°C)
0 – 80%
Calibration Traceable to National Institute of Standards and Technology
(NIST). Calibration controlled by software. Adjustments are
made through front panel keypad in a calibration mode activated
by rear panel switch. Calibration information stored in non-
volatile memory.