SMA 5000TL - Connecting the Multifunction Relay; Procedure for Connecting the Multifunction Relay; Operating Modes of the Multifunction Relay; Connection Options

6.4 Connecting the Multifunction Relay
6.4.1 Procedure for connecting the multifunction relay
Procedure See
1. Select for which operating mode you would like to use the
multifunction relay.
Section6.4.2, page32
2. Connect to the multifunction relay according to the operat-
ing mode and the associated connection variant.
Section6.4.3, page32
and Section6.4.4,
page37
3. After commissioning the inverter, change the operating
mode of the multifunction relay, if necessary.
User manual under
www.SMA-Solar.com
6.4.2 Operating Modes of the Multifunction Relay
Operating mode of multi-
function relay (Mlt.Op-
Mode)
Description
Fault indication (FltInd)
The multifunction relay controls a display device (e.g. a warning
light) which, depending on the type of connection, signals either an
error or the undisturbed operation of the inverter.
Self-consumption (SelfC-
smp)
The multifunction relay switches loads on or off, depending on the
power production of the PV system.
Control via communica-
tion (ComCtl)
The multifunction relay switches loads on or off according to com-
mands transmitted by a communication product.
Battery bank (BatCha)
The multifunction relay controls the charging of the batteries depend-
ing on the power production of the PV system.
Fan control (FanCtl)
The multifunction relay controls an external fan, depending on the
temperature of the inverter.
Switching status grid re-
lay (GriSwCpy)
The local grid operator may require that a signal is transmitted as
soon as the inverter connects to the utility grid. The multifunction re-
lay can be used to trigger this signal.
6.4.3 Connection Options
The connection procedures vary, depending on the operating mode.
Operating mode Connection option
Fault indication (FltInd)
Using the Multifunction Relay as a Fault Indicator Contact
Self-consumption (SelfC-
smp)
Controlling loads via the multifunction relay or charging batteries de-
pending on the power production of the PV system
6Electrical Connection
SMA Solar Technology AG
Operating ManualSTP5-12TL-20-BE-en-1532