SMA 5000TL - 8 Configuration; Configuration Procedure; Changing the Display Language

8 Configuration
8.1 Configuration Procedure
Once you have commissioned the inverter, you may have to adjust various settings via the rotary
switches in the inverter or via a communication product. This section describes the procedure for
configuration and gives an overview of the steps you must perform in the prescribed order.
Procedure See
1. If the display language is not set correctly, adjust the set-
tings.
Section8.2, page47
2. If you want to integrate the inverter into a Speedwire net-
work, connect the inverter to the network.
Section8.3, page48
3. Integrate the inverter into the network. Section8.4, page49
4. To manage the PV system data or to set the inverter pa-
rameters, capture the inverter in a communication product.
Manual of the communica-
tion product at www.SMA-
Solar.com
5. Change the system time and system password. Manual of the communica-
tion product at www.SMA-
Solar.com
6. If a residual-current device with a tripping threshold of
30mA was specified and has been installed, set the trip-
ping threshold of the residual-current device.
Section8.7, page51
7. If using the multifunction relay, ensure that the operating
mode is set correctly and adjust any further settings for the
operating mode as necessary.
Section8.8, page51
8. For partially shaded PV modules and depending on the
given shading situation, you should set the interval at
which the inverter optimizes the MPP of the PV system.
Section8.9, page52
8.2 Changing the Display Language
If the language for the country data set is not the language you want to use, you can change the
display language as follows:
Procedure:
1.
Danger to life due to high voltages
• Disconnect the inverter from all voltage sources and open the enclosure lid (see
Section10, page57).
8 Configuration
SMA Solar Technology AG
Operating Manual 47STP5-12TL-20-BE-en-15