SMA 5000TL - Protective Devices; Climatic Conditions

Grid configurations TN-C, TN-S, TN-C-S, TT (when V
N_PE
< 20V)
Approvals and national standards, as per
06/2017*
AS 4777.2:2015, AS4777.3, CE,
CEI0-21:2016, C10/11:2012,
DINEN62109-1, EN50438, G59/3,
G83/2, IEC61727/MEA, IEC62109-2,
NENEN50438, NRS097-2-1, PPC, PPDS,
RD661/2007, RD1699:2011, SI4777,
UTEC15-712-1, VDE0126-1-1, VDE-AR-
N4105, VFR2013, VFR2014
* AS4777.3: If DRM support is specified, the inverter may only be used in conjunction with a Demand
Response Enabling Device (DRED).
CEI0-21: only permitted with external decoupling protection.
C10/11:2012: only possible if the three-phase line-to-line voltage is 400V.
IEC61727/MEA: applies only to the STP9000TL-20.
EN50438: does not apply to all national appendices of EN50438.
IEC62109-2: This standard requires that either the multifunction relay in the inverter is used as fault
indicator or that the inverter is connected to SunnyPortal and that the fault alert is activated in
SunnyPortal.
NRS97-2-1: This standard requires a separate label be attached to the AC distribution board to
indicate the AC-side disconnection of the inverter in case of a grid failure (for further details, see
NRS97-2-1, Sect. 4.2.7.1 and 4.2.7.2).
11.3 Protective Devices
DC reverse polarity protection Short-circuit diode
Input-side disconnection point ElectronicSolarSwitch, SUNCLIX DC connector
AC short-circuit current capability Current control
Grid monitoring SMAGridGuard4
Maximum permissible fuse protection 32A
Ground-fault monitoring for STP5000TL-20 /
6000TL-20 / 7000TL-20 / 8000TL-20 /
9000TL-20
Insulation monitoring: R
iso
>385kΩ
Ground-fault monitoring for STP 10000TL-20 /
12000TL-20
Insulation monitoring: R
iso
>200kΩ
All-pole sensitive residual-current monitoring unit Available
Grounding conductor monitoring Available
11.4 Climatic Conditions
Installation in accordance with IEC60721-3-3, Class4K4H
Extended temperature range -25°C to +60°C
11Technical Data
SMA Solar Technology AG
Operating ManualSTP5-12TL-20-BE-en-1566