Mounting SMA Solar Technology AG
18 SB30TL_40TL_50TL-IA-IEN120231 Installation Guide
2. Attach the wall mounting bracket using appropriate
screws (diameter min. 6 mm) and washers (outer
diameter min. 18 mm).
3. Transport the inverter using the grip recesses on the
sides.
4. Attach the inverter to the wall bracket slightly to the
left of its final position.
The right edge of the rear panel of the inverter has
to be flush with the right edge of the wall mounting
bracket.
5. Check both sides of the inverter to ensure that it is
correctly in place.
To Next Page
Loading...
