SMA SUNNY BOY 4000TL - Operation; Display Overview

Electrical Connection SMA Solar Technology AG
44 SB30TL_40TL_50TL-IA-IEN120231 Installation Guide
5.5.1 Checking the Country Standard
Check whether the inverter is set to the installation country.
Before commissioning:
• Check that the country setting of the inverter is correct using the supplement provided and
comparing this to the the factory settings of the inverter.
After commissioning:
• Check that the country standard is correct on the basis of the display message during
(re-)commissioning (see section 6”Commissioning” (page53)).
or
• Check that the country standard is correct on the basis of the "SMA grid guard" measuring
channel via a communication device.
The settings of each country data set are specified in the operation parameters. The parameters can
be read out using a communication device. The description of the operating parameter is available
in the download area at www.SMA.de/en in the category "Technical Description" of the respective
inverter.
Display language
Once you have set the country standard, you can always set the display language later
using rotary switch B. However, you have to then set the rotary switch A to "0" in order to
keep the country data set.
(A) (B) Country data set Display language Grid guard
protection
Country
0 0 Delivery state Delivery state Dependent on
parameter set
Dependent on
parameter set
0 1 Retained English Dependent on
parameter set
Dependent on
parameter set
0 2 Retained German Dependent on
parameter set
Dependent on
parameter set
0 3 Retained French Dependent on
parameter set
Dependent on
parameter set
0 4 Retained Spanish Dependent on
parameter set
Dependent on
parameter set
0 5 Retained Italian Dependent on
parameter set
Dependent on
parameter set
0 6 Retained Not used* Dependent on
parameter set
Dependent on
parameter set
0 7 Retained Not used* Dependent on
parameter set
Dependent on
parameter set
1 0 VDE0126-1-1 German Yes Germany,
Switzerland,