Assembly SMA America, LLC
32 SB50US-80US-IA-en-36 Installation Manual
5.4.1 Mounting the DC disconnect
Dimensions of the DC Disconnect
Attach the DC disconnect to the two lower holes of the wall mounting bracket using the two screws
and washers provided.
1. Insert the screws with the washers through the holes
of the anchorage brackets of the DC disconnect.
The teeth of the washers must lie on the anchorage
brackets of the DC disconnect.
2. Put the DC disconnect onto the wall mounting
bracket.
3. Tighten the screws with a tightening torque of
44 in‑lb. (5 Nm).
To Next Page
Loading...
